Ref. QVU150
Thank you for choosing and the . By following these simple steps, you will be able to set
up and use your powerful Dual Scaler Hi-Resoluon Seamless Switcher based on ’s new Midra™
plaorm within minutes. Discover the capabilies and intuive interface while conguring your rst
show and unleash your creavity for a new experience in show and event management.
• 1 x
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device update)
• 1 x Remote Control Soware (RCS²)*
• 1 x Set of 6 audio 5-pin screw terminals
• 1 x Front Rack Ears (the parts are stowed in the packaging foam)
• 1 x User Manual (PDF)*
• 1 x Quick Start guide*
* User manual, quick start guide and the RCS² are available on www.analogway.com
You may wish to reset the unit to factory sengs to get
started. Go to:
Select the Output resoluon that matches the nave
resoluon of your display. You will next be prompted to
choose enable follow mode if desired and output rate.
Inputs can be congured automacally using the Auto
Set All funcon.
It will scan each input and detect the sync type that is
plugged in. You can sll do an Autoset or manual setup per
input.
The has 2 layers available called: and
.
To display a source, select a source (it will blink). Press
to transion your source from Preview to Program
output.
To view on Preview or change the contents of a dierent
source, simply select it. Only 1 layer can be seen on the
Preview.
To clear the layer select . Press to remove
the layer from the Program output.
If you would like the Program and Preview to toggle/
ipop during each Take, enable this feature by going to
.
Once enabled, the old Program output will become the
new Preview aer each Take.
See the next page which describes the buon lighng
color code and other front panel features.
- sources seamlessly switched in the .
If required, front handles of the
device can be dismantled, but
with cauon. The original screws
removed must not be reintro-
duced to their locaon without
handles in place. Substanal da-
mages can occur, including risk of
electric shock from the mains vol-
tage. Only M4x12mm screws can
be used. (They are supplied with
the unit.)
Comments to this Manuals