Analog-way QuickMatriX User Manual download pdf (Page 25)

6.2 Connecng with the RCS²



- Verify that you are using the correct network cable and that it is free from defects. (Crossover or straight

cable as required.)

- Check the IP address of both the device and the computer. It must have a unique IP address on the same

network as your QuickMatriX. You may need to manually congure a stac IP address for your computer in

your computer’s network conguraon.

- You may need to temporarily disable any other networks on the computer, such as turning o the wi

connecon.

- Close the RCS².

- Restart the RCS².

Once your computer has established connecon, the RCS² control panel will begin to load, and will begin to

synchronize with the device. When the small “Sync” icon at the boom right of the display has turned green,

the RCS² soware is ready to use.

Some computers use an energy saving mode that turns o the network adaptor during pe-

riods of inacvity. To avoid the inconvenience of reconnecng the soware during use, please

ensure your network adaptor remains acve by disabling the energy saving mode.

Enter the IP address of the device and then the remote port.

Click on SET AS DEFAULT if you want the soware to remenber

your conguraon.

Click on  to start the connecon.

Once connected, you have access to this screen:

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 86 87

No comments

Analog-way QuickMatriX User Manual Page 25