Analog way Eikos User Manual download pdf (Page 37)

A- SETTINGS IN MIXER MODE

To set up your inputs:

Input menu → Auto settings

You can also do it manually on each input# using the ENTER and the Knob button and set up the

inputs type one by one.

You can also check your actual input conguration using the cong status:

Input menu → Cong Status

You can nd several settings for each input (some settings are specic to some signal type):

- Type: to set up your input type (Computer, Video, etc..)

- Enabled/disabled: to enable/disable input#

- Audio input: to set up the audio regarding the input

- H sync. load: to change the load of the Sync. signal (Hi-Z, 75 ohms)

- EDID: to set up the EDID in terms of resolution and rate

- Status: to summarize the input status

Concerning the DVI inputs, a specic feature allows enable/disable the HDCP receiver for the input

chosen. It can be very useful especially using a Mac:

Input menu → DVI # → HDCP detection

* NOTE * : The input status is available at any time in status input menu and can give you information

about format rate and HDCP.

Input selection settings

Source Input selection

Plug your sources thanks to the 6 universal inputs, 2 DVI-I Inputs or 4 SDI inputs.

Don’t forget that the 2 DVI-I inputs can be used with DVI-D computer sources (DVI#1 & DVI#2) but

also with a DVI-A adaptor for analog sources too (source #5 & #6) shipped with your unit.

Be sure that all connectors are rmly attached using all available locking screws.

Input Sync. Loss Function

Allows to display a frame or a source in case of sync loss of the selected input. To set up the Sync.

Loss function:

Root menu → Control → Sync. Loss → Press Input# or Enabled

The selected input must be activated for being visible in case of sync loss.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 87 88

No comments

Analog way Eikos User Manual Page 37