Analog-way SmartMatriX Ultra User Manual download pdf

Ref. SMX12x4



Thank you for choosing   and the  . By following these simple steps, you

will be able to set up and use your Powerful mul-screen Seamless Switcher based on ’s new

LiveCore™ plaorm within minutes. Discover the  capabilies and intuive interface while

commanding top-notch presentaons and unleash your creavity for a new experience in show and event

management.

• 1 x 

• 1 x Power supply cord

• 1 x Ethernet cross cable (for device control)

• 1 x MCO 10 pin connector

• 1 x Web-based Remote Control Soware included and hosted on the device

• 1 x Rack mount kit (the parts are stowed in the packaging foam)

• 1 x User manual (PDF version)*

• 1 x Quick start guide*

* User manual and quick start guide are also available on www.analogway.com







The   uses standard ethernet

LAN networking. To connect the Web RCS to your

new , you rst need to connect

a computer to the   using the

Ethernet cable. Then on your computer open an

internet browser which supports Flash® player.

Into this internet browser, please enter the IP

address of the  displaying on the

front panel screen.

The connecon should start.

Oen, computers are set to DHCP client (automac

IP detecon) mode. You may need to change the

IP address conguraon on your computer before

you can connect. These sengs are found in the

properes for your LAN network adaptor, and vary

by operang system.

The default IP address on the  

is  with a netmask of 

Therefore, you can assign your computer a stac

IP address of  and a netmask of

 and should be able to connect.

If the connecon is not starng, please see:

• Be sure the computer IP address is on the same

network and subnet as the .

• Be sure that no two devices have the same IP

address (prevent IP conicts)

• Check your network cable. You will need a crossover

ethernet cable if you are connecng directly from

the  to the computer. If a hub

or switch is involved, use straight ethernet cables.

• For more informaon, please see the user manual

or contact Analog Way Technical Support.

Once you have successfully connected, the ash

app will automacally download and launch in your

browser. When the two icons in the boom right

corner of the screen turn green, the Web RCS is

ready to use. If you are having trouble syncronizing,

try clearing the cache and refreshing the page

(ctrl+F5 in most browsers):

-  will turn green when connected

-  will turn green when the Web RCS has

nished syncronizing.



The use of rear rack support

slide rails for all rack mounted

applicaons is highly recom-

mended. Damage caused by im-

proper rack mounng will not be

covered under warranty.

1 2 3 4

Summary of Contents

Page 1 - 

Ref. SMX12x4Thank you for choosing   and the  . By following these simple

Page 2 - See User’s Manual for details

Contextual buonsMenu scroll knobaccess Frame #1 to #4 or

Page 3 - 

 Setup assistant for adjusng all basic setups. Manage your outputs and have a

Page 4 - 

For complete details and operaonal procedures, please refer to the  User’s Manual and our website for further informaon: 